1 / 7
Amcrest IP8M-T2599EW-AI-V3 - Tiltable Mount
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A mount to screw the camera mounting plate into, allowing for tilt adjustment. Fits the Amcrest IP8M-T2599EW-AI-V3.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 74
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Share Alike
Didn't want to screw the camera into my wall and didn't find an existing mount, so I made one!
Fits the listed model but may work for others, see pic for roughly sketched measurements.
Will list them below as well, these are for the mount included with the camera:
- Total diameter: 3 15/16" (100.0125 mm)
- Center hole diameter: 2 9/16" (65.0875 mm)
- Outer ring diameter: 11/16" (17.462 mm)
- Distance from outer ring's inner edge to screw hole center: 3/8" (9.525 mm)
- Distance from outer ring's outer edge to screw hole center: 5/16" (7.938 mm)
- Screw hole depth: 1" (25.4 mm)
Printing:
- I used PETG, 20% infill, 4 perimeters, variable layer lines, no brim, support in the cross hole.
- Increase infill and perimeters if you need it stronger, decrease if you want it faster.
- Variable layers lines aren't needed but I used them to optimize print quality vs speed.
- Took about 2.5 hours on my Qidi Q1 Pro, not including the clasp it was attached to.
- Can use other plastics but if it's going outside, keep in mind UV/weather resistance.
- Highly suggest flipping the ball 180 degrees so the flat part of its stem is on the bottom.
Additional notes:
- Screw holes are not printed threaded, but will thread themselves as you screw.
- I suggest an electric drill, start off light then ease into it as it's a little tight.
- The ball's stem may require some elbow grease to insert but does fit if your tolerances are good.
- You can always print it slightly (1-2%) smaller and if it's too loose, super glue it.
- Remember to stick the ball's stem through the ring's wider opening and out the smaller one before inserting!
- The base is just a plain, flat bottom. I super glued it to a clamp I printed for mounting on a handrail but you can glue/print it onto whatever you need to “mount the mount”.
- The base's diameter is just about 15/16" (23.8125 mm) in case you want to model a hole for it to slot into.
- The ball and socket joint allows for about 30 degrees of tilt.