XFP Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a full parametric storage case for XFP modules.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 81
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
V1.1 slightly tweaked the size of the openings for a little less snug fit.
This case is meant for storing XFP modules (that used to be) commonly used in computer networking. While not watertight, it should keep out dust. The model includes two bumpers for the top and bottom to reduce the chance of breakage if it is dropped. They should be printed in TPU and affixed with contact adhesive (rubber cement).
I use 2 each of M3x20 and M3x30 cap head screws for the hinges and latch. (You can adjust these lengths in the onshape CAD model, and the hinges and catch with resize automagically.)
The model is available in onshape here. The version here in STL and STEP format is a 3x2 case, but the onshape version can be changed for any size. Additionally, screw sizes, XFP fit and lid clearance can all be adjusted.
The inspiration for this case was EMCBenni's Box for SFP, but I found it to be too loose for my liking. This is from scratch redesign, starting with the INF-8074i specification, and building it up from there.
So far, I have only printed it in PETG, with a 0.4mm nozzle. I have sliced it using Orca Slicer.
The catch piece is oriented on it's side and mouse ear brim, and 0.2mm layer height, and precise z-height selected.
The lid and case are printed without a brim. I also use precise z height, and ironing for all top surfaces. The case is oriented upright, and the lid upside down, neither with supports.
