No-hardware Match Saver for Breacher
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A match saver for Sillybutts' Breacher blaster with no hardware, for those whose hardware kits had no extra screws.
- Ocena
- 5 / 5
- Polubienia
- 24
- Pobrania
- 93
- Wydruki
- 1
- Wyświetlenia
- 593
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A Match Saver that attaches to the rail with a printed peg instead of screws. There's also small slots for lengths of 4mm PTFE tubing in the shell holder to reduce friction.
Print the Match Saver at 20% infill with 5 walls.
Print the Peg at 100% infill and 5 walls.
Be careful attaching the Peg! It's flexible, so gently hammer each individual spoke into the hole. To remove the Match Saver, gently hammer each spoke of the peg out in the other direction, being careful not to bend the spine of the Peg too much. It can and will break on you, depending on your print's clearances!