Guitar Pedal Tester Bodge Rig
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
(Audio In/Audio Out/9V/Ground --- 9V battery-powered box to ensure your audio device is correct before the foot-switch..
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 80
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution
Fuzzdog has a page showing how to wire up a Multi-Use Bodge Rig to confirm your guitar pedal works prior to adding your foot switch. This works with an M2-x4 threaded insert and I used a carbon steel machine screw because that's what I had. Galvanic corrosion is moderate I suppose. Again, it's what I have.
I tend to just use male to male jumpers from the 4 pins. That's a little sketchy. Might want to glue that bit into place once you're happy with it.
I used PLA with supports “Everywhere” just to be safe. Captain obvious says don't screw it closed until you know there are no shorts / your battery isn't heating up.
I might suggest you use a TRS jack that enables the battery only when something is plugged into it. The only area that needs improvement is the place where you plug the jumper wires in. Either glue it or seal it somehow so it doesn't move.
Here is the OnShape link is you want to modify it.