Rear or front bike mudgard
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A complete rear or front bike mudguard adjustable to suit your needs.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 205
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
Rear or front mudguard kit, adjustable to suit your needs.
I created it to mount on my Elops Speed 500 (a very lightweight single-speed) to prevent getting wet from my rear tire.
It will fit any 700mm (28-inch) wheel that's a bit thin thanks to its system of adjustable sections that allow you to choose the lenght of the mudguard by 1/16 of a wheel turn.
Printing instructions:
1 x start
1 x then
N x repeat depending on the size of the mudguard. 1/16 of a wheel = approximately 18 cm
1 x end
2 x fix
Assembly instructions:
The start section can be attached to the base of the seat with a clamp, as can the mounting rods at the hub.
The other parts fit together. I added a little glue to prevent them from moving.
Finally, the rods allow you to extend the end piece to reach the hub.
Thank you for your feedback in the comments; I hope this model will be useful to someone!