Ducati 1260 Multistrada Mirror Stalk Camera GPS Ball Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
There's not much useable space on the front of a Multistrada once you get a tank bag mounted, so I made up a ball…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 160
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
There's not much useable space on the front of a Multistrada once you get a tank bag mounted, so I made up a ball mount to go on the mirror stalk. I intend to use it as a camera mount but I suppose if you don't mind killing bugs with your GPS or phone you could mount those there too. I've shown it with a GPS but only because I'm not sure where my GoPro is at the moment... no, I don't run three screens when I ride.
Designed for a 1260 Multi but I think the 1200 and the 950 use the same mirror stalks?
Print Settings
Printer Brand:
Creality
Printer:
K1
Rafts:
No
Supports:
Yes
Notes:
The base works with either top piece, you only have to print one of them. For more security you can use the two piece upper - the ball ends up with a bolt running through it on that one. If you trust your printing skills you can use the one piece. The photo with all the parts shows the orientation I'd suggest printing them in.
The one piece upper mount has flat spots on the sides of the ball, use one of these to postion the part on the bed and use supports. Printing this upright will result in a weaker part due to orientation of the layer lines. The ball can be printed upright because the 5mm bolt running through it prevents seperation at the layer lines.
All hardware is 5mm. Button heads work best for the ball mount. I use nylocks under the clamp.
I used carbon fiber infused PETG for these but make your own choices for materials.
Category: Automotive