Ball screw SFU1605 tool to remove the screw
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tool to remove the Screw (diameter 16mm) of a SFU1605 ball screw for maintenance or other purpose.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 62
- Wydruki
- 0
- Wyświetlenia
- 212
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
I designed this tool to remove the nut from an SFU1605 (or any other 16 mm ball screw).
I needed to cut the flange for my SFX80 simulator to fit the slider of the 8080 aluminum profile. The screw was in the way during grinding, and I wanted to avoid damaging it.
To keep everything in place, I also made a secure nut that prevents the tool from slipping out during use — and from ending up in a mess.
This tool can also be used for maintenance or safe storage of the ball screw nut.
⚠ Attention! Be very careful — you can easily damage the ball screw or lose one of those tiny little balls. And once they’re gone, you’ll be crawling on the floor trying to find them again!
To use it:
- place the tool on the bottom side of the screw,
- hold the nut / flange down gently, and turn the screw until the tool slides in.
I recommend a bit of PTFE spray (or similar) as lubrication on the tube section.
If it doesn’t feel smooth, turn the screw back and forth slightly (without force) to avoid damage.
----------------------------------------------------------------------------------------------------------------------------
Please feel free to ask if there are any issues or if you have ideas to adapt.
If you like my work, give me a high five, post a make and/or leave a LIKE
→ I’ll share my experience reinserting those tiny balls soon — after learning the hard way on my third screw 😅
Here is the tool I made to re-insert the balls → https://www.printables.com/model/1464767-re-insert-assistance-tool-for-sfu1605-nut