Nissan NV2500. central cap
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A durable, 3D-printable replacement for the central cap on the Nissan NV 2500 van.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 77
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Standard Digital File License
I designed this model after losing or breaking the original cap (specify where the cap is located, e.g., "on the wheel hub" or "on the interior dash"). This is Version 4 of the design, which has been refined for a snug, secure fit and greater durability compared to my previous iterations. It snaps or friction-fits directly into place, just like the original part.
Printing Instructions
For best results, especially since this part may be exposed to the elements, I strongly recommend using a durable, temperature-resistant filament.
Filament Recommendation: PETG, ABS, or ASA (ASA offers the best UV resistance for parts exposed to sunlight). Avoid standard PLA if the cap is outdoors, as it can soften in high heat.
Layer Height: 0.2mm or 0.15mm for a smoother finish.
Infill: 20–30% for a good balance of strength and material use.
Supports: Minimal or none required, depending on your printer and the orientation you choose. Print flat side down if possible.
Perimeters/Walls: Use 3 or 4 perimeters for increased robustness.I designed this model after losing or breaking the original cap (specify where the cap is located, e.g., "on the wheel hub" or "on the interior dash"). This is Version 4 of the design, which has been refined for a snug, secure fit and greater durability compared to my previous iterations. It snaps or friction-fits directly into place, just like the original part.
Printing Instructions
For best results, especially since this part may be exposed to the elements, I strongly recommend using a durable, temperature-resistant filament.
Filament Recommendation: PETG, ABS, or ASA (ASA offers the best UV resistance for parts exposed to sunlight). Avoid standard PLA if the cap is outdoors, as it can soften in high heat.
Layer Height: 0.2mm or 0.15mm for a smoother finish.
Infill: 20–30% for a good balance of strength and material use.
Supports: Minimal or none required, depending on your printer and the orientation you choose. Print flat side down if possible.
Perimeters/Walls: Use 3 or 4 perimeters for increased robustness.