1 / 4
Promicro nicenano nrf52840 dongle case with reset button
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My remix of good dongle model by Lee.
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 64
- Wydruki
- 1
- Wyświetlenia
- 478
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Public Domain
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 1) (Komentarze: 1)Remiksy (0)Kolekcje (13)Powiązane
This is my remix of already good model by Lee. Main change is adding button to the dongle.
You need small SMD button 4*4*1.5mm, as shown on photos.
Just cut two legs from the one side, and solder two other legs direct to RST and GND pins on the board. Dont use to much solder, otherwise it will prevent lid to close, amount shown on photo is completely enough. You maybe will need to slightly bend legs to best fit distance between pins (check picture to see how it should look).
