5-in-1 Saltshaker
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small saltshaker capable of holding up to 5 different spices
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 320
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Share Alike
A basic spiceshaker I'm working on for some time now. This is MK6 and finally working as I want it.
It can hold up to 5 different spices and is relatively easy to print.
To assemble you'll additionally need an M5 threaded insert and a short M5 bolt to hold it all together. After adjusting the screw tension for good rotatability of the two rings you shoul use some loctite to hold the screw (and thus the tension on the rings) in place.
Additionally you can ad a small TPU seal (just a piece of standard 1.75mm diam. TPU filament) in the grove of “Körper”.
Not necessariely required but cool to have are some ballpoint pen springs and ball bearing balls. Snip the springs to length (you'll have to use some trial and error) and put them into the small round holes in “Körper”. On top of them you add a ball bearing ball.
Now the shaker will snap into place at each spice with a satisfying click. (You may have to experiment woth the amount of springs and their length. You most likely won't need all 5 holes)
A funnel to fill up the assembeled shaker can be found her:
(Link pending)
Have fun :)