FlightScope MEVO Gen2 Level
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
MEVO Gen2 clip-on bubble level.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 59
- Wydruki
- 0
- Wyświetlenia
- 260
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution
As a new FlightScope MEVO Gen2 owner I wanted to speed up my setup. This is a clip-on bubble level that will quickly get you very close to the recommended 12* tilt and 0* roll. Use is simple. Just drop it on top of the MEVO Gen2 and level as usual (shims, leveling table, etc.), then confirm your setup in the FS Golf app.
The level is a generic round 32mm x 7mm bubble level from Amazon. https://www.amazon.com/dp/B098D4XFJW
I printed this one on a Prusa XL in PLA+ with organic supports. The loop interface option left the cleanest support surface for the level. PETG would be a good choice for weather resistance, but since it gets used for about a minute at a time PLA+ seemed OK. Print with the legs pointing upward of course.
The spool in the 3rd picture can be found as FlightScope MEVO Setup Spool. Both pieces fit in the factory case if you don’t take the charger to the driving range. https://www.printables.com/model/1464951-flightscope-mevo-setup-spool
The leveling stand in the picture is here: https://www.printables.com/model/1474088-flightscope-mevo-gen2-leveling-stand
A 3MF file is included in case you want to make some changes.