NYC Traintrackr Wall Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wall mount / frame with power slot for the a NYC Traintrackr.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 121
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Wall-mounted
- Licencja
- Creative Commons — Attribution — Noncommercial
I wanted a frame to hold my NYC Traintrackr (I believe v2.0 though check the photos to see if your's matches), while having a little slot for the power cord to go behind it. It came out pretty nice. There are little triangle ridges to use a couple nails to mount on the wall. I also used a bit of double sided tape to hold it in place.
I printed it in black PETG, though PLA should be completely fine as well.
The screw holes are for M2.5 screws, though depending on the accuracy of your printer, you may wind up having to use slightly different screws.
I used a 180 degree USB C Adapter to get the power to quickly go through the hole and into the back.
I've attached a 3mf file that can be directly sent to a slicer for printing, along with a Fusion 360 file that can be used to make changes in Fusion 360 as needed.
This design was hand measured. After I finished up I found out they have open source outline files which could have made measurement more accurate: https://github.com/Traintrackr/board_files/blob/master/outlines/mta3_outline_v1.dxf.