Case for Heltec's HT-HC01P WiFi HaLow Dev Board
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case designed for the Heltec WiFi HaLow Module Mini PCIe dev. It is a snap lock 2-part case with 2-color logos.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 89
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Case for Heltec's HT-HC01P WiFi HaLow Dev Board
https://heltec.org/project/ht-hc01p/
This is a case designed for the Heltec WiFi HaLow Module Mini PCIe dev board listed above. It is a snap lock 2-part case with no screws or magnets. The 2-color print can be simplified with no logos by removing the modification adjustment for each object if you cannot easily print multicolor. Will fit on any print bed, and tested in ABS with no warping or breaking on repeated opening and closing.
The individual female header ribbon cable intended to be used with your Raspberry Pi or Tachyon development SBC has the slots at an angle for insertion or removal. Once inserted on the board's pins, and the case is snapped shut, the angled squares will hold the female header pins in place preventing accidental removal--reverse the process for uninstalling. This is a tight fit but manageable.
Print solid, with no supports. On an H2D you will not need a purge tower if printing 1 color per nozzle. Turn that feature on if you are printing 2-color on one nozzle.
Please leave feedback.
- Heltec WiFi HaLow Module Mini PCIe x 1: https://a.co/d/7WfQhce
- 10dBi Meshtastic 915MHz LoRa Soft Whip Antenna with SMA Male Connector for Heltec x 1: https://a.co/d/59IRp6Q