TMC5160T Plus 4x Bracket for Annex Engineering Gasherbrum-K3

I'm running the XY motors on my Annex Engineering K3 at 48V, and I'm using BTT's external TMC 5160s (TMC5160T Plus) as the stepper drivers. I needed to mount them, and specifically, I needed enough room for an Octopus Pro (mounted vertically/tall), four external drivers, and two SSRs with heatsinks side-by-side in the space between the two electronics box extrusions, with a Flexpower x7 PSU basically filling the entire bottom of the box (and then some). So, this is what I put together.

If you're using BTT's heatsink cases, these almost certainly won't fit. If you're using Buttermilk Crispy Chicken Salad's 5160T Plus case, it should just barely fit, although you'll probably choke the fans a bit.

You'll need two of the A pieces (the long base piece that bolts to the extrusions), and four of the B pieces (the brackets that the actual 5160s bolt to). Each B bracket takes four standard Voron M3 heatset inserts, and four M3x10mm bolts to attach everything. Screwing it together is a little fiddly, as it's a fairly tight fit, but you should be able to assemble the whole thing outside of the ebox, and then use an allen key on the extrusion bolts. Refer to the CAD for assembly.

No scaling for shrinkage has been applied to either the CAD or the STLs; if the filament you're using needs it, please apply it in your slicer.