Reinforced Bondtech BMG V6 Mount For Ender 3 / CR10
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Just a quick remix to cross-reinforce the bracket. See the original for the remaining parts, it is the absolute best…
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 62
- Wydruki
- 0
- Wyświetlenia
- 1039
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Just a quick remix to cross-reinforce the bracket. See the original for the remaining parts, it is the absolute best direct drive + V6 design I've seen yet, though it would frequently break off when tightened down. This remix tries to address that by adding perpendicular material reinforcing those areas where breaking happened in my experience.
It can print fine as-is without supports if your cooling is good enough but I suggest using tree supports for best results.
Print Settings
Printer:
Modded Ender3
Rafts:
No
Supports:
Yes
Infill:
100
Filament:
carbon fiber pla PLA
Notes:
PETG is also a good potential choice for strength.
Category: 3D Printer Parts