Honda Fit/Jazz 2nd Generation Cruise Control Switch Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Insert this part to hold down the cruise control button if the original spring-loaded button breaks
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 408
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This part was designed for my 2013 Honda Fit (2nd Generation), but it may fit similar Honda vehicles with a steering wheel cruise control switch from the same time range (around 2007-2013).
I created this model to keep the cruise control button depressed in my car after the spring-loaded button suddenly broke mid-drive. Now that I have the ability to print in PETG, I decided it was time to design something to replace the paperclip I was using. #MacGyver
Print Settings
PETG, 0.4mm nozzle, 0.2mm layer height, 1 wall, 0% infill, Mouse Ear brim.
Installation Instructions
Slide the narrow side up into the open area above the button until reaching the top guide. Next, push it down against the button and slide it downward into the opening below the button until the middle guide is centered. The cruise control switch should now be depressed/active. To remove, you may slide the part either up or down to easily release and pull it out.