Sandevistan (Militech Themed)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Militech themed Sandevistan which uses magnets for mounting, and LED strips for lighting.
- Ocena
- 0 / 5
- Polubienia
- 23
- Pobrania
- 79
- Wydruki
- 0
- Wyświetlenia
- 693
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Cosplay & Costumes in general
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Made my own take on the Sandevistan.
Includes Vertebrae, a Tail Piece, a Neck Connector, and a Neck Piece. Also includes Diffusers for each, which is meant to be printed in transparent filament.
The print profile has hollows in the tail piece and vertebrae for a 20mmx3mm magnet, with a print pause so you can insert the magnet. I recommend putting a bit of superglue before adding the magnet, and giving it a few minutes, since the nozzle may attract and displace the magnet.
The channels can take LED strips up to 10mm in width. I kept the battery pack on my belt, though a back pocket also works. If you need help to make a belt carrier for your battery pack, let me know.
I used super glue to fix the diffusers, and double sided tape to hold the LED strips down. I let the LED strip + wiring carry the neck connector over.
You shouldn't need supports to print it. Internal may be a liiiiiil messy but it'll be fine.