Sega Saturn USB Daemonbite Enclosure For MiSTer FPGA / PC
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Daemonbite enclosure for USB-C Arduino Pro Micro board (ATmega32U4) and Sega Saturn controller port for MiSTer FPGA.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 117
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
The goal was to design a minimalistic enclosure that would allow for inclusion of an arduino pro micro board (ATmega32U4) and OEM Sega Saturn style controller port. The design is based on a USB-C version of the arduino board. The arduino board has a snug fit - please be sure your arduino board will fit properly. It's possible some arduino boards may use slightly different sizing.
Printing Suggestions:
Material - PLA
Enclosure base - I recommend printing this component with the flat surface on the print bed. Layer height .14mm first layer and .20mm remaining layers. I used 15% infill. I only used supports for the 4 screw hole countersinks. I did not use supports for the USB-C port cutout, however depending on your printer, you may want to enable supports for that as well.
Enclosure top - I recommend printing this component with the flat surface on the print bed. Layer height .14mm first layer and .20mm remaining layers. I used 15% infill. I did not need supports for the angled edges.
Adapter Parts Used:
- (1) Arduino Pro Micro board (ATmega32U4) with USB-C connector (board dimensions: 35mm L x 18.4mm W x 1.65mm H)
- (1) Female Sega Saturn controller port
- (4) 12mm M3 hex screws
- (1) 5mm M1.4 screw
- (4) 5mm M3 brass screw inserts
- 22 or 28 gauge silicon wire