OFD Flycore x Wolves Core (Hurricane Straight | Angled)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modded OFD Flycore that uses the V5D pusher mechanism from The Wolves Core.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 251
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
ONLY FOR HURRICANE FLYWHEELS. CRUSH WIDTH: 32.5MM.
For pusher hardware, print settings, and assembly instructions refer to The Wolves Core instructions: https://www.figma.com/design/aQI5ZwVc6uWxBcLphwGVux/The-Wolves-System?node-id=0-1&p=f&t=NrJlDuSVj4dvrept-0
Note: The stock pusher might work but is too short for it to feed darts into the flywheels since the pusher assembly is set back 4.4mm to not clip into the magazine well. An extended pusher is supplied.
You'll need the appropriate mag detent for the respective flycore being used as the mag detent is shorter for the angled mag core compared to the straight mag core.
For the Flycore hardware, print settings, and assembly, refer to the OFD Flycore page: https://www.printables.com/model/245307-ofd-flycore-angled-design-your-next-printed-blaste
This body uses:
- 6 x M3 x 5(OD) x 6mm heat inserts + 1 optional heat inserts at the front of the flywheel body.
- 4 x M2.6 x 12 Flat head countersunk (self tapping) screws to hold the pusher mechanism to the body.
- Compression spring 0.7mm (WD) x 6mm (OD) x 20mm (L)
EDIT (Nov 3, 2025): Added STEP files for those that want to build blasters around it.