Jan Vitek's Sewing Box - Screwed version
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A not fully 3 printable foldable box for sewing accessories
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 316
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
I liked a lot the sewing box but i don't trust glue, so i tought ‘screw it!’
The modified model gives up the full 3d printability and needs to be kept together through a number of M3 countersunk screws, precisely:
- 32 M3x12
- 2 M3x25
- 5 M3x8 (only for split bottom version)
In return you won't have to rely on glue adhesion and it will be possible to disassemble most of the box to swap damaged parts or change colors (feet and holders are still to be glued)
This page contains only the modified parts, mids, tops and lids are available in the original model page
If you go for the full bottom version the 5 pin_bottom are not necessary and only 32 pin_cap should be printed