1 / 3
Knoll Generation Chair — Arm Rest Pad (TPU replacement) — zdjęcie 1
1 / 3

Knoll Generation Chair — Arm Rest Pad (TPU replacement)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A simple, comfy drop-in pad to revive a worn or torn Knoll Generation arm rest.

Ocena
0 / 5
Polubienia
1
Pobrania
6
Wydruki
0
Wyświetlenia
116
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Knoll Generation Chair — Arm Rest Pad (TPU replacement)

A simple, comfy drop-in pad to revive a worn or torn Knoll Generation arm rest. I modeled this to match the OEM arm rest footprint and the curvature of the support shell with some modifications for easy 3d printing, then printed it in flexible TPU so it’s soft on the elbow but still durable.

Photos show my original (shredded) pad and the TPU replacement installed.

Mirror it to print right arm rest. Use double adhesive tape to install on arm rest base.

Features

Designed for Knoll Generation arm rest shell (the curved plastic piece with oval slots).

One-piece TPU print—no foam, no upholstery, no stitching.

Curved top surface for comfort; edges gently radiused to avoid snags.

Light, slightly cushioned feel with internal infill to tune firmness.

Print Settings (tested, well balanced firmness)

Material: TPU 85A

Nozzle: 0.4 mm (0.6 mm also great)

Layer height: 0.2 mm (0.28 mm for 0.6 mm nozzle)

Perimeters (walls): 4

Top/Bottom: 6 top, 5 bottom

Infill: 10% (Gyroid)

Speed: 20–35 mm/s

Temp: 180–200 °C nozzle, 45–60 °C bed

Cooling: 30% after L3–L5

Retraction: Minimal/low for TPU

Adhesion: 5–10 mm brim

Supports: Full supports required (details below)

Support Setup (TPU-friendly)

Type: Normal support good for TPU

Where: Everywhere

Density: 8–15%

Pattern: Lines / Grid (Tree if available)

Support interface: On

Interface layers: 2–3

Top/Bottom interface density: 60–80%

Z-distance (air gap): 0.2–0.3 mm (≈1 layer)

XY-distance: 0.5–0.7 mm

Support speed: Slow (15–25 mm/s) to avoid TPU snagging

“Support on build plate only”: Off (needs internal support)

Paint supports only under the overhanging edges if you want less cleanup.

Orientation

Print flat on the bed (pad side up).

Ensure first-layer squish is even so the perimeter doesn’t curl.