Umbrella hanger remix by REAL-C with nicer ST logo (NO MMU needed!) FIESTA / FOCUS / PUMA etc.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of @Depa_638714 's design but with a nicer (IMHO) ST logo in 2 parts so it can be printed in another colour etc.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 140
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
I liked @Depa_638714 ‘s a lot but for some reason my MK4s didn’t give the “ST” logo a proper finish so I went for a 2 parts solution after having experimented with wheel hubs in the past.
Like I said above the pocket in the main part is 1 mm deep and the logo itself is 1.2 mm high, I find it to be the best combo to give strength and a nice finish.
A higher logo doesn't help the end product trust me, the files are in step though so help yourself if you want to try different logo heights.
Just glue the logo in at the end, super glue or equivalent are okay, make sure to make lots of very small points all the way on the back of the logo rather than long lines, it doesn't need much and you don't want the glue to come up on the sides after you've pushed the logo in its pocket. ;)
Printed in Prusa PETG Lip stick red and the logo was printed in Prusa PETG Galaxy black on a MK4s, other settings:
-Go all in with perimeters
-Seams → nearest
-External perimeters first
-Doesn't need supports
-Standard 0.15 or 0.2 structural profiles, 0.1 for the logo itself.
-100% speed
-I think in general 255 degrees C for the hotend is too much with Prusament PETG, I go for 245 degrees C max for the print (not for the first layer), it gives nicer results and strings a lot less, even with dried PETG.
-Print the hangers on their sides.
-Flip the logos in the software upside down so you get the nice grainy finish from the buildplate on the visible side of the logo, print more than 2 just in case and print them one-by-one (sequential printing).
Dry your PETG well.
This is what I did.
It works for Fiesta ST MK8 I believe it also mounts on the PUMA and the FOCUS from what I hear here and there.
Enjoy!
PS: the pictures suck, sorry I was in a hurry, will try to upload better pictures.