Gamma toolhead remix - heated inserts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remixed to allow the use of heated inserts. Also reinforced at smaller holes.
- Ocena
- 4 / 5
- Polubienia
- 3
- Pobrania
- 46
- Wydruki
- 1
- Wyświetlenia
- 339
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
Simply added parts/negative parts in Orca to suit my needs. The inserts are ment to be added to the front part with the M3 screws going in from the back. Standard Voron M3 inserts work best but others might work too (read lower part).
If you want to avoid the inserts and just use M3 screws, simply change the diameter of the “negative cylinders” to 2.5 mm (ish).
You can also remove the “additive thoroidals” if you'd like to have the screws flush as originaly intended. I, however, would rader sacrifice 1-2 mm in Y-range and use flat screws insted of chamfered ones to avoid the possibles cracks that appear between the layers at the thin walls by these holes (has happened before).
If you like it go tell the original creator and give him a buck! Great original design!
4/11-25 Update: Fixed some small issues. Added more material for the inserts to melt into. Also fixed the prebuilt support that kept failing on my prints.
PS: The holes are as long as they're allowed to be without compromising the model! If you push the heated inserts in too long or use too long screws you will break it!