F1-Style rear wing v2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
F1-Style rear wing v2
- Ocena
- 5 / 5
- Polubienia
- 19
- Pobrania
- 153
- Wydruki
- 2
- Wyświetlenia
- 1467
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Attribution — Noncommercial
Design changes:
- Lighter base connector
- Thinner end-plates
- Fewer and bigger airfoils
- Now with two wing designs (low drag and
- Swept wings
Files included are:
- Frangible base mount
- Low drag profile wing
- Regular profile wing
Connecting the wing halves:
To connect both halves of the wing together, A rectangular plastic piece should be inserted in the slots where the middle sections meet. Depth of each slot is 15mm. Just measure the height and width of the slot entry and print a rectangular piece that fits. Use some drops of glue to hold full wing together
Fasteners required:
- 4x M4x16 screws
- 4x M4 nuts.
- 8x M4 washers (optional)
Wearable safety precaution:
The base mount is made up of a thin strut design. The middle intersection should get filed down such in the event of an accident, the base can break under tension.
Category: Vehicles