NO SCREWS Remix for Centauri Carbon Recirculating & Noise Reduction Air Handling Assembly

I despise M2 screws. They're impossible to install. They use a 1.3mm hex that strips if you look at it wrong. This remix gets rid of the M2 screws and uses 2x of the existing screws from the OEM assembly. The intake and fan mount slide into the blower plate and are retained with a single screw each. So ok, 2 screws, but you already have them and they won't strip when you install them.

Also added a place to mount the board, clips to hold the wires in place, and mounting place for carbon filter. 

You will need to route the 4 pin fan connector above the cross bar. Just remove the rear enclosure (all short screws and the bottom 2 of the poop chute), remove the 4 pin from the existing clips (and some tape), and route it above the crossmember behind the fan assembly. There's an overhang to keep it out of the belt area and it just clips into the board from the enclosure side. To get the aux fan to work at the lower position, you'll need to extend the wires or use jumper wires.

NOTE: The carbon filter and the holding tabs protrude a bit into the space that the tool head moves in when doing the purge and clean, so I've added a "No Filter" version. Will try to shrink everything down to remove interference even with the filter in place.

EDIT: Removed the version that included the filter and added a chamfer that makes the tool head less likely to contact the blower plate. Makes it more difficult to print but there's no free lunch is there.