3/4" J Channel Jig for 12mm Pixels
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is for the 3/4" J channel that I got from Menards. This is for the 12mm RGB Pixels. Currently, 2" center spacing.…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 337
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
This is for the 3/4" J channel that I got from Menards. This is for the 12mm RGB Pixels.
Currently, 2" center spacing.
The "short" jig saves plastic and printing time but will only do 2" and 4" spacing.
You can use the outer cut to align with your drill bit.
The size tester is a small print so you can test your j channel with how this jig is designed.
Print vertical, no supports needed. Print at least one pin for alignment. I do check detect bridging parameters in Prusa Slicer.
Category: Other