CSM Yarn Cone Spoke for NZAK & Jeeping Johnny V2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A royal cone holder for CSMs without tables or for better cone control!
- Ocena
- 0 / 5
- Polubienia
- 51
- Pobrania
- 69
- Wydruki
- 0
- Wyświetlenia
- 484
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This cone spoke will fit yarn mast poles 8.6mm (0.34in) dia or smaller and has been test fitted on an NZAK (shown in blue) and Jeeping Johnny V2 (not shown). The mast hole in the cone spoke does have some extra tolerance which may cause it to tilt away but I have not noticed it causing a problem. The lip for cones is 46mm (1.8in) dia and 8mm (0.31in) tall, fitting cones from royal cone winders and pandel's Yarn Cone Winder V2 https://www.printables.com/model/690302-yarn-cone-winder-v2-manual-or-motorized. Cones do not lock into this lip so a rough bump will knock your cone off however if your CSM snags your cone jumping may mitigate a bigger issue. Not recommended to use for more than 100g.
- Wall loops: 3
- Top shell layers: 4
- Bottom shell layers: 4
- Sparse infill pattern: Rectilinear
I have also included cups to convert the cone holder into a tool cup. The solid .stls are for printing in vase mode. This is shown in the background in green with an early iteration of this design.
If you don't have a printer or way to print please consider my Etsy shop.