1 / 1
LiberNovo Omni Armrest Tension Spacer V2 — zdjęcie 1

LiberNovo Omni Armrest Tension Spacer V2

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A simple spacer to add to the Omni's armrests to significantly increase tension.

Ocena
5 / 5
Polubienia
12
Pobrania
367
Wydruki
0
Wyświetlenia
1672
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

UPDATE [4/30/26]: In lieu of Libernovo changing the hollow square slot to be solid, I have designed a newer version that will work with all models and is stronger. After taking apart my armrest after months of using the first version, I noticed the spacer has embedded itself partially into the rubber so it was losing a bit of strength. V2 here offers a larger flatter surface that will help prevent this. Time will tell if it holds up.

My test print settings:

  • PLA+ (regular is good too)

  • .2mm layer thickness

  • 50% grid infill

Directions:

  • Take off the armrest by taking out the single screw, lift up the back and apply first side to side pressure and it should come off. There are 6 clips (3 on each side) that hold the armrest on.

  • After the top is removed, unscrew the two large bolts and pull that swivel section out along with the underside of the armrest.

  • Once the print is done, flip it over and place it behind where the front bolt inserts. Should fit nice and snug.

  • Reassemble and enjoy (and don't forget to print my other forward/back slider mod!).

Tagi