1 / 1
Science Olympiad Boomilever 2026 Division C Tension Member Jig — zdjęcie 1

Science Olympiad Boomilever 2026 Division C Tension Member Jig

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a tension member jig for 2025-2026 Science Olympiad Boomilever event.

Ocena
0 / 5
Polubienia
5
Pobrania
104
Wydruki
0
Wyświetlenia
847
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Engineering
Licencja
Creative Commons — Attribution

Summary

This is a tension member jig for 2025-2026 Science Olympiad Boomilever event. The distance between the bolt mounting hole and the bottom of the surface is 150 mm, comply with the construction parameters. It could be used for both bonus and non-bonus designs for division C.

Printing

Layer Height: 0.2mm

Supports: None

Infill: Cubic 15%

Filament Material: PLA

Required Hardware

  1. Connector Bolt, 1/4-20 x 2.36 inches (60 mm) long, with a 0.66-inch (17 mm) diameter head and 0.78 inch (20 mm) unthreaded section, 1 required. (Figure 3)

  2. Hex Nut, American National Standard, 1/4 — 20, 0.23-inch-thick maximum, 2 required. 

  3. Flat Washer, USS 1/4 inch, approx. 3/4 inch outside diameter x 0.09-inch-thick maximum, 2 required.

Link to purchase these hardware

Usage

The Connector Bolt will have a hex nut and flat washer on the front side of the Testing Wall and a hex nut and flat washer on the back side of the Testing Wall. Connector Bolt is installed to allow 3.0 cm +/- 0.1 cm (1.18 inch +/- 0.03 inch) clearance between the closest face of the Connector Bolt to the Testing Wall and the Testing Wall face.

Source: Science Olympiad

Update

The new version added another bolt mounting hole for bonus design. When the bolt is mounted on the upper hole, the jig will be for building non-bonus design; when the bolt is mounted on the lower hole, the jig will be for building bonus design.

The new version also added Vertical Contact Width (CW) Lines, which is 40 mm from the center line.

Tagi