1 / 2
Less frustrating MK3S+ Y Belt tensioner — zdjęcie 1
1 / 2

Less frustrating MK3S+ Y Belt tensioner

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Minor tweaks to the stock files for the Y belt holder and tensioner to make this step of assembly far less frustrating

Ocena
4,833 / 5
Polubienia
80
Pobrania
333
Wydruki
6
Wyświetlenia
2546
Oceny
6

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v2.0

Building the MK3S+ is great fun - until you get to Step 29, assembling the belt on the Y-axis. Getting the length of the belt right is tricky, but making it worse, the design of the stock Y-belt holder and tensioner sink the nut more than necessary, making it very hard to hold in place while trying to set the screw. The screw included is an M3x10 which winds up not being fully engaged on the nut threads, and makes each attempt at attaching the belt to the printed pieces really frustrating.

My adjustment takes the original STLs and makes the nut pocket shallower, only the 2.4mm depth of a standard M3 nut, and I swapped out M3x12 screws from the spares pack.

Trying to get the Y-axis belt properly set was taking me far too long and it was far too frustrating. Once I tried it with these adjusted pieces, I was able to get it right on the first go with no frustration at all. Prusa makes great stuff and I'm sure there's a reason that the original design is like it is, but I find this far, far nicer.

I'm also including the F3D files I created from the STLs. The conversion from the mesh to the prismatic body says the compute failed (you'll see the icon is yellow) but the body is valid. These are being made available if you wish to modify it further. 

Tagi