DIY Powerbank 18650/26650 QC4.0 100W
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
DIY powerbank case for 25 18650 cells with QC4.0 QC3.0 LED Dual USB 5V 4.5A 100W Micro/Type-C USB control board
- Ocena
- 0 / 5
- Polubienia
- 24
- Pobrania
- 92
- Wydruki
- 3
- Wyświetlenia
- 791
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
A case for a power bank control board that fits 25x 18650 or x 26650 cells.
You will need these parts:
1x power bank control board - you can buy it on Aliexpress
The module is great, with 2 USB outputs, 1x USB-C input/output with fast charging, 1x Micro-USB input, and 1x Lightning input. The module supports passthrough (ports can be used while charging) The state of the battery is shown via LCD.
18x M2 heat insert
2x M2x5 screw
16x M2x8 screw (HEX or Cheese Head)
25x 18650 cells
Print the case in PETG (due to heat made by batteries and board). The LCD bracket should be printed with transparent filament or resin. You wil have to desolder the LCD and solder some wires to connect it.
I used some foam to insulate the free space between the batteries and housing.
The cells are connected in series, the total capacity of my cells is about 13Ah, but you can use any cells you like. You need to adjust the resistor on the board according to your cells total capacity. See the Aliexpress listing page for more details.