1 / 6
Gridfinity Storage for Anest Iwata LPH-50 detailing Spraygun — zdjęcie 1
1 / 6

Gridfinity Storage for Anest Iwata LPH-50 detailing Spraygun

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The Anest Iwata LPH-50 is the smaller sibling of the LPH-80. This Gridfinity accommodates it and the mandatory regulator

Ocena
0 / 5
Polubienia
0
Pobrania
5
Wydruki
0
Wyświetlenia
128
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution

The Iwata LPH-50 detail airbrush is less common than its larger sibling, the LPH-80. The LPH-50 is popular with scale modelers; the LPH-80 is aimed more at automotive and similar work.

Both the LPH-50 and LPH-80 require a regulator attached directly to the gun, and it’s also common to see a ¼" NPT male quick-disconnect on the setup. Because regulator bodies and quick-disconnect positions vary by brand and model, the regulator’s location can differ enough that designing a single, universal contour case is difficult.

I learned that the hard way. I own two LPH-50s with the same regulator brand and model; I printed one case set thinking it would fit both. One gun fit perfectly — the other did not.

If you want to store an LPH-50 with its regulator attached, here’s my solution:

Plate 1: Snugly holds the LPH-50 itself. It should need little or no adjustment during printing — this one printed perfectly on the first try.

Plate 2: This is the lower “generic” part of the case with the cutout that accepted my first gun but rejected the second. You should treat Plate 2 as the adjustable base that you’ll modify for your specific regulator/quick-disconnect placement.

Plate 3: A 1.5 mm template of the gun with the regulator and quick-disconnect attached. It matches (shadows) the cutouts in Plates 1 and 2. This is a quick, simple print that helps you see how your setup differs from mine (Plate 2). Mark on this template what you need to remove. I used Bambu Studio's "add negative part", printed the part, and….perfect.

Plate 4: An example of the changes I made to fit my second gun. I opened Plate 2 in Bambu Studio, added two negative shapes where needed, and that solved it. NOTE: this is an example only — it’s extremely unlikely your setup will match mine exactly, so Plate 4 is not intended as a print-ready file.

Plate 5: The same “shadow” as Plate 3 but 15 mm tall to accommodate the side cup connector. I printed this in TPU scaled to 99% so it would slide in more easily.

Everything was printed using Panchroma Charcoal Black (except the TPU plate, duh), 0.4 nozzle, and 0.2 layer height. Infill was 15% cubic.

There probably aren’t many LPH-50 owners, but for the few of you who have one, this should be useful.

Tagi