1 / 2
Coffee Filter Holder for Melitta #2 and Hario V60 (100 count)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adaptable coffee filter holder model, parameterized in Fusion 3D.
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 62
- Wydruki
- 2
- Wyświetlenia
- 242
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 2) (Komentarze: 2)Remiksy (0)Kolekcje (14)Powiązane
Parameters of note in the f3d file include:
- Holder depth - 2 inch by default (for 100 filters).
- Wall angle - 40 degrees for Melitta, 45 for V60.
- Holder top width - Width of the holder at the top, 6 inches by default.
Adjusting these parameters should allow you to make a holder for a variety of conical filter types aside from the ones mentioned in the title.
Photos show the Melitta version, 100 count capacity.
