Milwaukee M12 Inflator Skadis Hook
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replaced holes with 2x Skadis spaced holes sized for M2.5 SHCS
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 125
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Remix of the wall hook that I could use on my Skadis board.
Sized the holes for the M2.5 SHCS, should be a min length of 14mm.
I have two versions uploaded, 2 mount holes spaced at 80mm apart to skip a slot and 3 mount holes spaced at 40mm to have access to an extra. I modeled the three hole version first but realized it would be overkill so only printed the two hole variant. Three holes is uploaded in case you want to overhang an edge or have an extra, it's usually covered so aesthetics probably won't be a concern.
I also uploaded steps and the Fusion file in case you want to mess with the hole sizes. Since I printed it on the end the holes were oblong and while the screws fit in fine, maybe you want to improve them.
Print shown is PLA, 0.2mm layer height, 2x perimeters, 15% infill.