Prusa Core One Electronics Cover With Quick Release MMU3 Cable Socket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of previous model
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 19
- Wydruki
- 1
- Wyświetlenia
- 654
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Quick-Disconnect Electrical Cover for CoreBoxx
I use the CoreBoxx on my Prusa CORE One, but there are times when I need to remove it from the top of the printer so I can print with other materials. Disconnecting the cable each time was inconvenient, so I designed this remix to make removal much faster and easier.
With this setup, the cable can be disconnected and the CoreBoxx lifted off the printer in under 10 seconds.
This remix is based on the original design, but I was not happy with having to reach inside the enclosure to unplug the cable. To solve that, I used the shorter cable supplied with the MMU3 kit and created a connection point between the xBuddy Extension board and the electrical cover using a 12-position Molex receptacle.
Connector Modification
The connector has two metal grounding tabs on the ends. These need to be carefully slid out, bent in half, and reinserted. This allows the connector to sit securely inside the electrical cover and gives it proper support. See the photos for reference.
Please note that the connector is a surface-mount component, so the soldering required for this modification is fairly small and will require some skill.
Parts Required
1 × Molex 5031541290 – 12-position receptacle�
2 × M3 × 6 mm screws for the hold-down
Printing Notes
Printed in PETG
No supports required
The cover includes raised lettering if you would like to print it in multiple colors