BMAX B4 Turbo - 19-inch (2U) rackmount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 19-inch (2U) rackmount for the BMAX B4 Turbo
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 258
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a 19 inch rackmount for the BMAX B4 Turbo which is 99.9% supportless.
Make sure to print the part with the face placed onto the print bed. That orientation requires no supports.
I recommend printing using PETG for strength and heat resistance.
If you own a different model of the BMAX mini-pc that also fits, please let me know and I'll make sure to update the description.
Optional (tiny) support
It can probably be 100% printed without any supports, but personally I'd like to add a tiny bit of support to the keystone slot just to make sure it's fully solid. These are the 2 floating areas as marked in dark blue in the pictures below. Use the support draw tool (infill) to select these; then set support to “normal (manual)”.
The tiny bit of generated support is very easy to remove.
Required parts
- 4x M5 screws (Min size: 10mm, max size: 16mm).
- 4x M5 hex nuts.
- 1x keystone coupler per side
Assembly instructions
- Place a Keystone coupler in the keystone slot
- View how to combine the 2 halves with pictures at the original model and follow those steps.
- Print a rear panel for every left and/or right side you print, and either glue or plastic-weld it in place. I made this a separate part so you didn't need to waste plastic on supports only for this part. They can only fit in 1 way, so no worrying about doing it wrong.
- Connect the rear ethernet cable to the keystone, and put some tape over the hole. This ensures that only cool air is pulled in by the mini-pc from the front of the rack, not warm air from the rear.
- Place the mini PC
- Mount it in your rack!
Credits
- If you only want to print the left or right side, and want a blank panel for the other side, make sure to check out the original model made by Maurício Pessoa. These are compatible; though I had to remove 2 of the screw mount holes. Because of this I would recommend only combining this with a blank 2U version; not the 1U version.
- The Keystone slot model that I used was made by Paul Lützner and can be found here. Big thanks to him for this model.