Lancia Ypsilon / Chrysler Ypsilon Phone GPS mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This design is made to fit inside the already existing GPS mount on the Lancia Ypsilon models 2009 - 2013.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 156
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Public Domain
This design is made to fit inside the already existing GPS mount on the Lancia Ypsilon models 2009 - 2013. It slides into the already present “EasyPort” connector and enables you to attach a ball and socket type phone mount which can be found for cheap on the internet. It removes the need to have a suction cup on the windshield which can leave residue or come off.
Printed using Bamboo Lab A1 with PETG. It is recommended to print on its side, with supports as to maximise load bearing strength. Bending will still occur if the cabin gets too hot even in PETG. Unfortunately there is no way around this apart from using ASA since the part can reach 90 degrees in the sun.
There are 2 versions of this mount:
For the revised model (recommended): the tabs on the side make the mount hard to insert, however this ensures the mount does not fall out due to vibrations. The fit is extremely tight and not designed to be removed, however the tabs can be filed down to make them shorter.
For the non-revised model: if the mount is too loose I recommend adding a layer of sticky tape to where the mount slides in to increase the diameter and make it harder to remove, however it will eventually vibrate out due to the nature of the design, therefore the revised version is recommened.