Qidi Q2 Camera Hood (eliminate LED light bloom/flare)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Snap on camera hood to help eliminate lens flare and blooming from LED lights.
- Ocena
- 5 / 5
- Polubienia
- 90
- Pobrania
- 635
- Wydruki
- 7
- Wyświetlenia
- 2844
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Clip on Camera Hood for the Q2 to reduce flare and blooming from LED lights. One is for front (stock) and 200mm LED light bar (see my other models) and another that blocks entire top (for people with risers with light strips). Suggest printing in black (opaque) filament rated to handle chamber temps (65C). I do not have a riser with lights so a bit of guesswork on the full top model.
Remove the screw holding the camera. Tilt the top of camera (no need to remove cable). Snap the hood onto the camera (start with small latch on top left then push at lower of hood to snap the hood in place over the lens). Tilt camera back in normal position and reinstall screw. Done!
Printed face down with 4 walls / 5 top and bottom / 15% Honeycomb3D infill / no supports needed