1 / 3
DIY "Bootleg" HEPA + Carbon Filter for Prusa XL's Enclosure (Modular and Refillable) — zdjęcie 1
1 / 3

DIY "Bootleg" HEPA + Carbon Filter for Prusa XL's Enclosure (Modular and Refillable)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

An affordable DIY replacement with modular filter layers for the Prusa XL's Enclosure.

Ocena
0 / 5
Polubienia
7
Pobrania
17
Wydruki
0
Wyświetlenia
231
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution

Bootleg Prusa XL Carbon + HEPA Filter (Modular & Refillable)

A modular, refillable carbon and HEPA filtration unit designed as a functional, low-cost alternative to the stock Prusa XL filter assembly. Built for maintainability and independence from proprietary consumables.

I made it in FreeCAD after noticing the lack of available options that would fill this niche.



Key Features:

Refillable Carbon System: accepts any standard activated carbon granules between 2–4 mm in size (tested with 4 mm pellets). You can use bulk aquarium or air purification carbon - cheap, effective, and widely available.

DIY HEPA Sheets: supports hand-cut and folded HEPA filter material. Replace only what’s needed, not the entire assembly.

The construction is fully modular. Each major filtration element - carbon compartment, carbon grill, and HEPA frame - slots and clips into the Main Box for quick access and partial replacement.




Assembly:

Main Box – the central housing; slightly undersized to accommodate double-layer adhesive tape and salvaged foam seals from original filters.

Carbon Compartment – holds the activated carbon bed.

Carbon Grill – secures the pellets and prevents them from entering the HEPA stage.

HEPA Frame Box – contains the HEPA sheet folds; clips into the main box.

Mesh Attachment:
Attach mesh to the carbon parts using a low-temperature iron (around 240 °C for PETG or lower for PLA). Use nylon mesh if possible - it resists deformation during assembly. Mesh can be salvaged from the stock filter or sourced separately.

Print Specifications:

Material: PETG (recommended), PLA also compatible.

Layer Height: 0.2 mm.

Supports: minimal, only for the HEPA frame clips.

Post-processing: if clips fit too tightly or don't slide in, file or trim lightly on the supported side for clean snapping action.

 

 

Design Intent:
This “bootleg” XL filter prioritizes serviceability, cost efficiency, and component longevity. Instead of discarding entire units when carbon or filter media degrades, you can selectively swap, refill, or reconfigure each element based on material quality and availability.

Tagi