Daytona Pinch Weld Adapter - Magnetic Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Magnetic mount for the Daytona Pinch Weld Adapter from Harbor Freight
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 169
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Public Domain
A little boredom and some Jack Daniels resulted in a magnetic mount for the new Daytona Pinch Weld Adapter from Harbor Freight. Stupid simple and holds the adapter strongly at all orientations.
I used two #6 x ½" screws and left the just above flush with the top of the mount. Three 60mm x 10 x 3 magnets glued into the bottom for excellent mounting strength.
Magnets:
https://a.co/d/hKpQAGp
Note:
I printed mine upside down with supports and it came out almost perfect (low standards). Otherwise would need supports all along the underside which could be hell to clean off.
Hope this helps at least one person OCD on their toolbox setup…