Massage Gun 2oz Paint Shaker
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
2oz acrylic/craft Paint shaker attachment for massage gun.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 361
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
This is an attachment for a massage gun to shake 2oz bottles of paint. It should work with most if not all bottles. the massage gun used was a Darkiron which is just a generic cheap massager from Amazon, so check the shaft diameter before printing to make sure it fits. The diameter of the model is 18.6 mm with a length of about 22.34. There is an impression at the top of the shaft for a rubber ring. This is used for extra grip so it doesn't shake loose. My massage gun came with extras for attachments, but a rubber band would also probably do the job. Additional rubber bands should be used to hold the paint bottle in place as shown.
- Material: PLA+/PTEG. I used PLA+ regular PLA might work, but it might be too brittle to withstand the impact of the massage gun over time.
- Nozzle: 0.4
- Layer height: 0.2
- Orientation: Flat on back as show in pictures.
- Support: Below the shaft.
- Strength: 3 walls, 15% 3D Honeycomb
- Optional: The base near the gun is where the strength matters, so you can add a modifier to print the walls around the paint with less infill. I did 8% Adaptive Cubic.