ODROID N2/N2+ Case

This case is a remix of the ODROID N2 case sold by AmeriDroid. This version makes it easy to print without supports and requires no hardware to use with the N2/N2+. The case protects the components from damage and dust. 

Special thanks to Hardkernel for providing the original STEP files.

If you want to mount your N2/N2+ to a wall, check out my mounting bracket here.

The OROID N2/N2+ is a fantastic single board computer with roughly 2x the power of a Raspberry Pi 4. The N2+ powers the Home Assistant Blue device and I highly recommend it.

Printing

• Print in PLA, PETG, or PC. If the N2/N2+ will be in warm conditions or overclocked consider using a heat-tolerant filament like PETG or PC instead of PLA.
• Print using a .2 or .3 layer height.
• 2 Perimeters/shells.
• STLs are pre-positioned in the correct print orientation.
• Supports not required.

Usage

• When using with a MicroSD card, plug the card in prior to attaching the case. The card can be removed/inserted with the case on, but ease of SD card access was traded in this version  for easier printing. I recommend using eMMC modules with the N2+ over SD cards.
• To expose the GPIO header, carefully trim the tabs on top of the case.
• When attaching the case, slide the “lip” of the walls into the corresponding side grooves of the N2/N2+ heatsink. The wall “lips” can be seen in the posted picture of the case on the build plate.

Happy Printing!