Camera Mount with Cable Guide -Logitech C922 Pro

Camera Mount for 25.4 x 25.4 mm aluminium extrusion with cable guide to keep the cable tidy, protected, and out of the way. This is a good snap fit onto the extrusion. I designed the original for use around the Logitech C922 Pro but it works with any other camera with a standard tripod mount. The hole for the mounting screw is deliberately undersized to be drilled out per best customisations.  The current mounting screw hole is designed around a M4 cap bolt. 

The print is not an overly tight fit surrounding the camera, I deliberately ensured an overall 1.125mm gap which gets swallowed up. I glued a piece of felt front and rear to cushion any printing vibrations.

I used PET, PLA works fine.

Additional:

2x M3 x 14 mm Cap Screws
2x Locking Nuts (M3 x 4mm) 
Felt or like soft material

N.B. I use M3 x 12mm Cap Head Screws to give a refined tidy finish, they have enough thread but 14-15mm would be easier to wind on initially.

If you like this please consider buying me a coffee: https://www.buymeacoffee.com/missionrea9

Edit: added version without cable guides as requested

Edit: added camera base for adjustability as requested. 

N.B. I made the camera base with square corners as opposed to round corners to facilitate a better tighter grip. When testing I found installing the camera base into the bracket asap after printing gives an almost permanent adhesion. The tolerances are extremely tight making for a very secure bond. No screws required if inserted while still warm and a little malleable.

Find the Logitech C922 Pro Privacy Screen here: https://www.prusaprinters.org/prints/148065-logitech-c922-pro-privacy-shield

Fine version 2 here:
https://www.prusaprinters.org/prints/152151-camera-mount-with-cable-guide-v2