Pico 4 ultra Gun new (Glock Shell)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Glock based gun shell for the pico 4 ultra controller
- Ocena
- 0 / 5
- Polubienia
- 23
- Pobrania
- 114
- Wydruki
- 0
- Wyświetlenia
- 984
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Virtual Reality
- Licencja
- Creative Commons — Attribution
I was dissatisfied with the previous gun i published because is bulky and unrealistic, also rather uncomfortable. so i designed another on e using Notthingham82's Glock as starting model.
i suggest to print the front part laying on the slope that leads to the pico controller plate, the black plate vertical trigger on the side and side connector on the internal flat surface .
i al so strongly suggest to use fuzzy skin on the grip
Pilot holes are already in the model to be drilled, use a piece of filament for the trigger pin.
note if you find the trigger to be too light, jis add a a rubber band as i did in the picture.
mirror everything except the connector to print a lefty version.
usual safety precaution when using both VR and gun props apply.
some offest compensation are needed in steamvr.
Have fun.