1 / 1
Parametric universal cordless modular drill mount / holder — zdjęcie 1

Parametric universal cordless modular drill mount / holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Parametric drill holder for mounting on a vertical surface. Works well with french cleat.

Ocena
0 / 5
Polubienia
23
Pobrania
104
Wydruki
0
Wyświetlenia
451
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Parametric wall-mounted holder for cordless drills (Hikoki, Makita, Bosch, Dewalt, etc.)

Screw it to the wall, or to a board attached to the french cleat (as on the picture).

To the sides it has holes for 16x5 mm shelf dowel pins (like these). These serve mainly OCD management. i.e. they make the modules line up even when loaded by the tools. The secondary benefit is that they allow to spread the dynamic load between the modules when tool is placed. 

Intended screws are 3.5mm in diamater with a length of 10 mm plus whatever you want the backing material penetration to be. I used 3.5x25mm.

The dimension is spacing between the arms - most of my tools fit well the 55mm one.

Prints on 235x235 bed, but smaller one would also be functional (this length allows me enough space to leave bits in some drills). 

I printed it in PETG for the layer adhesion and creep resistance. 5 vertical walls, 6 top & bottom layers, 30% gyroid infill. Needs approx 120g filament for 55mm module.

Overall it was a bit of experiment - the design assumes loading the print along the layer lines, which is not optimal. I expected it to break, but after 18 months it still works fine.  @kerngebiet's design is strictly better in this regard, but I wanted something that's freely top-loaded.

Tagi