Precice Lithophane Calibration .4mm-4mm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Calibration model for lithophane
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 73
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a gradient lithophane Calibration model. It starts at 0.4mm on the right and goes all the way up to 4mm In .2mm increments.
This is for calibrating your more opaque white filaments as it only goes up to 4mm in thickness. When printing lithophanes with Opaque filaments you don't get as much variability in thickness from your darkest to your lightest. This calibration ensures you get the most out of your lithophanes. Use this to find the thickness at which the gradient no longer produces noticeable changes.
I I also added a shorter version to get the print times below 25 minutes if printing at a .2mm layer height. (My photos are using a .08mm layer height)
Print standing upright at either 99% or 100% infill