Waves - Kinetic Front Cover - MasterFrame 600
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A moving Front Cover for the MasterFrame 600 Case
- Ocena
- 0 / 5
- Polubienia
- 37
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 646
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
Turn your case into a living art piece.
-----
Printing:
The number after the x in the name means how many times a part must be printed.
The Spindel is he most challenging part. Printing in PLA should ok as it wont get that hot at the front of the case, hopefully… But the spindel most be as rigid as possible so use 15 wall Loops to get a nearly complitly filled part.
The vertical bar is the opposit, use as little as posible, use as little as possible to make that part as ligh as possible to enable the movement.
The Spindel Attachment should be printed in ABS/ASA to prevent creep.
-----
BOM:
3x 608 Bearings
1x 50cm x10mm Steel Rod
1x TT Motor
-----
Build Instruction:
- Sand the top and botton of the Linkages and the Verttical Bars to reduce friction.
- Glue the Spindel Parts tother in the following order: Spindel Gear - Spindel - Spindel - Top Spindel Mount
- Insert 2 Bearings into the Spindel Attachment.
- Insert the steel rod into the Spindel Attachment.
- Add all vertical bars on the steel rod, put grease between each element to reduce friction.
- Add the Spindel into the bearing in the Spindel attachment
- Add the bearing to the Top Mount and place it mount on top of the assembly
- Add all linkages by glueing them in place
- Attach the TT Motor to the Drive Gear and attach them to the Spidel Attachment
- Add the assembly to the case