DS18B20 Climate Shield
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Climate shield made to hold 1x DS18B20 (Waterproof) sensor.
- Ocena
- 5 / 5
- Polubienia
- 34
- Pobrania
- 182
- Wydruki
- 3
- Wyświetlenia
- 1253
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Climate shield made to hold 1x DS18B20 (waterproof) sensor.
Including a mount that fits the railing system inside Juliana Greenhouses and the corresponding bolts/nuts (might fit other greenhouses with similar systems)
Needed materials:
- 4x M4x25 screw (tapered head)
- 4x M4 nut (used locking nut, but regular should fit as well)
- Superglue (whatever you prefer to glue parts together with)
Print instructions:
Print 1 of each STL, except ‘layer 4-5-6’ which you need 3 of. (more if you want more air above sensor)
Print Mount with a raft.
Printed on Prusa i3 MK3S+, PLA+/PLA MAX, 15% infill, 0.15 layer height, no support needed.
Assembly:
- Screw Bottom and Layer 1 together with M4 screw + nuts.
- Glue layer 2 to layer 1, apply small bead of glue around notch on layer 2.
- Glue rest of the layers together, and press together so it lines up even.
Note! They should fit together, depending on precision of printer there might be some pegs/holes that needs a bit of trimming with stanley knife/sandpaper
Once everything is glued together, you can now unscrew the bottom from the rest and insert sensor through the bottom into the holder in the upper part. Screw together again and place cable into the trench in the bottom.
Happy Tinkering!