Core One L Magnetic Adapter (Replaces Spool Holder)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Magnetic Plate to replace the spool holder on the right side of the printer
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 532
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
I wanted to replace the spool holder on the right side of the printer with something easier to change out. The wall inside this space is not magnetic on it's own.
There is the base plate that screws into the same position as the spool holder and then a plate to use as the base for things to attached to it.
It takes 40x10x5mm bar magnets, 4 in the base plate and 4 in the attachment plate. Here are the ones i'm using: amazon.com/dp/B0D6G4RLGB?ref=ppx_yo2ov_dt_b_fed_asin_title. They are not a snug fit, but super glue keeps them in place within the plates until you get them attached at which point they are covered on both sides anyway.
I didn't make the chamfer big enough to not pinch you entirely if you aren't careful, but if you just rotate things first and then square them up when the magnets kick in, you shouldn't have any issues.
In the picture, I've attached the plate to the bottom of my MMU3. It holds it in place with no issues.