Clover Lattice Christmas Ornaments 2025
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Elegant ornaments to decorate your tree
- Ocena
- 5 / 5
- Polubienia
- 36
- Pobrania
- 131
- Wydruki
- 1
- Wyświetlenia
- 535
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Winter & Christmas & New Year's
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Here are three beautiful ornaments for the tree! The closed version (center in the picture) is the easiest to print.
I've provided my Prusaslicer 3MF files and Prusa MK3S+ GCODE in addition to my STL/OBJ files. If you try importing the 3MF files into a different Orca based slicer, some settings may not carry over. Slice it and check for problems. Also, I would not use my GCODE on other printers.
All three designs require supports. I've provided a support blocker for the closed version. Without it, slicers want to add supports in places that you can't remove once it's printed.
The open designs require supports in places that can be a challenge to remove. But I think it's worth it. If you have water soluble supports, use them. If not, grab a hobby knife, side cutters, a dental pick, and pliers. Then, take your time.
I used a single perimeter in most places. I used 2 perimeters at the very bottom and top to make the prints stronger. I recommend using the Classic perimeter generator, not Arachne (the default in modern slicers).
For the closed design, I used lightning infill everywhere. For the others, I used height range modifiers to add infill only where it's needed.